Wd My Book Not Installed Fatar Eroor Show

It sounds like your **WD My Book** is showing a **“Fatal Error”** or similar “Not Installed” message — that usually means the drive’s firmware, filesystem, or hardware isn’t being recognized by the system.

Here’s how to break it down and troubleshoot:

---

## 🔍 **1. Clarify the Exact Error**

* On **Windows**: Does it appear in **Disk Management** but not in “This PC”?

* On **macOS**: Does it show in **Disk Utility**?

* On the **WD LCD** (for My Book Live / Duo / Studio models): Is “Fatal Error” displayed on the screen?

If you confirm where the message appears, it’ll help determine if it’s:

* **Drive hardware failure**

* **Corrupted partition / file system**

* **Enclosure (SATA-to-USB) failure**

---

## 🛠 **2. Basic Checks**

1. **Change the cable** → Use another USB cable (preferably the WD original if possible).

2. **Try a different USB port** → Preferably a rear port on a desktop (direct to motherboard).

3. **Try on another computer** → To rule out host issues.

4. **Listen for noises** →

* Repetitive clicking → possible head crash (mechanical failure).

* No spin at all → power issue.

---

## 🖥 **3. Check if the Drive is Detected**

* **Windows**:

* Press `Win + X` → **Disk Management**.

* See if the drive appears (even as “Unallocated”).

* **macOS**:

* Open **Disk Utility** from Applications → Utilities.

* Check if it appears under “External”.

* If it shows **RAW / Unallocated**, the partition table is likely damaged.

---

## 🧩 **4. If “Not Installed” or “Fatal Error” is in the WD Dashboard**

For models with **WD SmartWare or Dashboard**:

* This message means the **drive’s firmware failed to load**, or the enclosure board is not reading the disk properly.

* Sometimes caused by **bad sectors in the firmware area** or **enclosure controller failure**.

---

## 🩺 **5. Recovery & Fix Options**

### **A. If Drive is Still Detected in Disk Management**

* Backup immediately if possible.

* Run **CHKDSK** on Windows:

```cmd

chkdsk X: /f /r

```

(replace X with your drive letter)

* Or use **WD Data Lifeguard Diagnostic** to run **Quick Test** and **Extended Test**.

### **B. If Drive Is Not Detected at All**

* Remove the drive from the WD My Book enclosure (only if out of warranty).

* Connect directly to a PC via SATA or a good-quality USB adapter.

* If still not detected → mechanical or PCB failure (needs professional recovery).

### **C. If the Enclosure Board Failed**

* WD My Book external boards often use hardware encryption.

Even if the disk is fine, you can’t read it without the **original board** (or identical model board + ROM chip transfer).

In this case, data recovery specialists are the safest route.

---

## 🚫 **Important Warnings**

* Do not format unless you’re okay losing data.

* If data is critical, stop testing and use a professional recovery service immediately.

* WD hardware encryption means bypassing the enclosure without decrypting can result in unreadable data.

---

If you tell me:

* **Exact My Book model**

* Whether it’s showing the error **on the drive’s LCD, in WD software, or on the computer**

* And whether the drive **spins up or clicks**

…I can give you the exact next step, including **whether you can DIY fix or it’s a data recovery case**.

Do you want me to walk you through **My Book “fatal error” LCD screen recovery** steps specifically?